Specifications

4 Communication settings and guide of HMI connecting with controller
NOTE
：The PLC panel must be set up, press” Enter”, then press” △”, until show e
press ”Enter” to enter “COM SERV” interfaces (not SERV, it must change to SERV)
In accordance with the above settings, the serial line access, EV5000 can be communicated with the
Rexroth Controller L40 by serial port.
◎Supported Device
Device Bit Address Word Address Format Notes
BYTE
B0000-9999 ------ DDDD
WORD ------ W0-65535 DDDDD
INT
------
I0-65535
DDDDD
UINT
------
UI0-65535
DDDDD
DWORD
------
DW0-65535
DDDDD
DINT ------ DI0-65535 DDDDD
UDINT ------ UD0-65535 DDDDD
◎Cable Diagram
PPC-R RS232 communication cable
com2
3 TX
2
RX
5 GND
8 TX
7 RX
5 GND
com0/
com1
Controller terminal
15 pin D-SUB (male)
2 TXD
3 RXD
7 GND
HMI terminal
9pin D-SUB female/male
PPC-R RS485 communication cable
- 47 -