Specifications

4 Communication settings and guide of HMI connecting with controller
PLC Setting
PPC-R software setting
PLC connects with PC via crossover ethernet cable. If using cross-connection ethernet cable, you must add
a HUB (we usually use a cross-connection line to access the Internet)
Hardware configuration：
1. Click”scp configurator”--->”scanning ”or” add device”--->”next”, pay attention to the default
controller IP: 192.168.1.1. And set IP 192.168.1.1 in the software (PC and controller must be set up in
the same segment), ping IP address is OK, that configuration is successful. Save and close “scp
configurator”--->”refresh” to see logical devices created in configured logical devices”, double-click to
enter. All configurations will be successful.
2. Open ”indralogic”--->”online/communication parameter”--->”new” and select ”TCP/IP” to
modify “value”, set IP address the same as controller: 192.168.1.1
- 42 -