Specifications

4 Communication settings and guide of HMI connecting with controller
PLC software setting: “Hardware Configuration”double click “Ccom” to select “MODBUS/BUS
LINK”; others are default parameters.
Cable recommended by Schneider Electric Industries, Rotary switch setting: 3 (OTHER Direct)
RS485 communication cable
PLC software setting: “Hardware Configuration”double click “Ccom” to select “ MODBUS/BUS
LINK”; Others are default parameters.
com0/com1
HMI terminal
9pin D-SUB female/male
Controller terminal
8 pin Mini Din (male)
1 RX-
6 RX+
5 GND
2 D-
1 D+
5 DPT
7 GND
Schneider Twido Modbus RTU protocol
RS232 communication cable
Cable recommended by Schneider Electric Industries
RS485 communication cable
com0/com1
HMI terminal
9pin D-SUB female/male
Controller terminal
8 pin Mini Din (male)
1 RX-
6 RX+
5 GND
2 B-
1 A+
5 DPT
7 GND
4.67 SHIMADEN FP23
◎Serial Communication
Series CPU Link Module Driver
FP23 FP23 RS485 on the CPU unit SHIMADEN FP23
◎System configuration
Series CPU Link Module COMM Type Parameter Cable
FP23 FP23
RS485 on the CPU unit
RS485 Setting Your owner cable
◎Communication Setting
Default communication parameters: 9600, 8, even, 1; station: 1
- 292 -