Specifications

4 Communication settings and guide of HMI connecting with controller
Tune I Float
Tune D Float
Mode Double
IN BIT
QN BIT
PIN Float
PQN
Float
NT Double
FT
Float
B
BIT(the attribute of B is the same as N32 in the PLC software)
BT BIT(the attribute of BT is the same as NT in the PLC software)
NOTE：
1
、 The configuration in OPTO 22 software must be the same as the configuration in EV5000
software
：
true：e.g.: define Float in the OPTO 22 software，F1
Select FN device in the EV5000 software, address: 1.
Communicate correctly
error：e.g.: define Float in the OPTO 22 software，F0001
Select FN device in the EV5000 software, address: 1.
Communicate error
2、 PIDSN correspondence
If it set up PID1 in the OPTO 22 software, it can show the values of Input, SetPoint, Output, Gain,
Tune I, Tune D, and Mode.
In the Ev5000 software, PIDSN format DDDDD.DD, Address can be written in 1.**.( the main address
in front of decimal point corresponding to the OPTO 22 of PID1 1 ,sub-addr refer to the table. the table
as follows:
Sub Address（Example PID1，1 is sub address）
Corresponding Value
1.00 Input
1.01
SetPoint
1.02
Output
1.03 Gain
1.04 Tune I
1.05 Tune D
1.06 Mode
◎Cable Diagram
Ethernet communication cable
Cross-connection or crossover network cable can be used as communication cable via the hub
Refer to
4.3 Download by Network Ethernet for method of making connection cable.
- 257 -