User Manual
Table Of Contents
- SIMATIC ITP1000
- Warning notice system
- Preface
- Table of contents
- 1 Overview
- 2 Safety notes
- 3 Commissioning the device
- 4 Devise functions and operating the device
- 5 Device maintenance and repair
- 6 Technical specifications
- A Technical Support
- B Labels and symbols
- C Abbreviations
- Index
Devise functions and operating the device
4.1 Notes on operation
SIMATIC ITP1000
Operating Instructions, 01/2017, A5E37340160-AA
43
4.1.7
Using camera
Optionally, the device can be ordered with a camera.
Information on the position of the camera lens, the lighting and the LED of the camera can
be found in the section "Back (Page 12)".
The camera is operated with the pre-installed YouCam software. You can use to take
pictures and record videos. You will find information on the functions and setting options of
the camera in the documentation of the YouCam software.
Lighting and flash
CAUTION
Observe safety instructions
The camera LED is assigned to Risk Group 2 according to IEC/EN 62471. Before using the
flash and the light, make sure to note the safety instructions in section "General safety
instructions (Page 20)".
● The use of the lighting can be configured using the function keys. You can find additional
information in section "Buttons (Page 15)" and section "Configuring the device
(Page 40)".
● The lighting is active for 30 seconds after activation.
● The quality of the image depends on the local lighting conditions.