User Manual

Commissioning the device
3.3 Power supply
SIMATIC ITP1000
Operating Instructions, 01/2017, A5E37340160-AA
31
3.3.2
Connecting the power supply
The battery charges as soon as the device is connected to the power supply.
Note
Always operate the device with the battery inserted.
For the proper operation of the device with
external power supply, a battery must be also be
inserted.
When connecting to the power supply, note the information in the section "Charging the
device (Page 39)".
Note
Power supply only with the original power supply unit
Only use the supplied original power supply unit
for the power supply of the device. This
applies to both the connection to the device and to the connection to the docking station.
It is used to supply power to the device in mains operation with 120
V and 230 V power
supply networks.
The setting of the
voltage range takes place automatically.
Procedure
1. Insert the supplied power supply cable into the external power supply.
2. Insert the low-voltage connector into the corresponding socket for connection to the
power supply on the device or to the docking station.
3. Plug the external power supply into a socket with a grounded protective conductor.
The device is operated with line current. The battery is charged during the operation.
Note
No mobile operation of the device when the power supply is connected
When connected to the power supply, only operate the device on a table or in the docking
station, refer to section "
Left view (Page 13)".