Specifications

A. Cut slot and holes in enclosure flange for operating

handle (1), provide mounting holes for circuit breaker (2)

and support member (3) as shown.

B. Weld interlock latch (4) to inside of cover. Additional cover

securing means also required.

C. Loosen four cover screws (5) and remove terminal shields

(14). Insert four 1/4-20 x 23/4 in. screws (6) with lockwasher

(7) and flatwasher (8) through mounting holes of circuit

breaker (2) and tighten securely to mounting surface.

Make terminal connections and reassemble the circuit

breaker terminal shields.

D. Mount support member (3) by means of four 1/4-20 in.

slotted pan head screws (9).

E. The operating handle (1) and interlock assembly (10) are

supplied preassembled. Before disassembling note the

position of the levers on the interlock assembly with

respect to the operator. Care must be taken to insure this

relationship is maintained when the device is reassembled.

F. Assemble operating handle (1) with gasket (11) from

outside of the enclosure and interlock assembly (10) from

inside of the enclosure by means of two 3/8-16 in. hex

nuts (12). When correctly assembled the operating handle

cannot be moved from the OFF position to the ON

position while the cover is open.

G. Pick up actuating member assembly (13) at hex head

screw and assemble to support member (3). NOTE: Be

sure the nylon rollers engage circuit breaker handle, U-

slot engages operator and actuating member engages

slot in support member. Tighten hex head screw se-

curely.

Operation

The handle cannot be operated from the OFF position to the

ON position with cover open unless the interlock mechanism

is deliberately voided. This involves turning the screw in the

handle housing counterclockwise before moving the handle.

For inspection with power on, rotate same screw clockwise to

open the cover.

(1)D11JLU, D11JL4U designate left-side handle operators; D11JRU, D11JR4U designate

right-side handle operators; D11JL4U, D11JRU are for use with 4-4x applications.

Types 1, 4, 12

I-T-E Slide Handle Operator

(D11JLU, D11JL4U, D11JRU, D11JR4U)

(1)

Figure 1

Figure 2

Figure 4

Figure 3