Specifications

24
I-T-E Handle Locking Devices
ATTACHING I-T-E HANDLE BLOCKING DEVICE
(J6HBL)
To Block Handle ON
Turn Breaker ON. Assemble blocking device to breaker by
positioning over handle as shown, with handle opening of
blocking device toward the line end. Insert tab A into slot A1.
Push toward handle and downward in area shown (Figure 1)
until tab B drops into slot B1 (Figure 2).
To Block Handle OFF
Turn Breaker OFF. Reverse handle blocking device so that
handle opening of blocking device is toward the load end.
Insert tab A into slot B1. Push toward handle and downward
in area shown until tab B seats in slot A1 (Figure 3).
ATTACHING I-T-E PADLOCKING DEVICE (J6HPL)
With breaker in TRIPPED position, assemble padlocking
device to breaker by positioning over handle as shown. Insert
tab A into slot A1. Pivot tab B into slot B1 until surface D is
resting on surface C (Figure 4). Install #6-32 x .188 non-
removable screws (2 places).
To Lock Handle OFF
To padlock handle in OFF position, move breaker handle to
OFF and move slider to the right until .375 in. dia. holes line
up, allowing padlock to be installed (Figure 5).
To Lock Handle ON
To padlock circuit breaker in ON position, enlarge 12 in. dia.
hole of slider to .375 in. dia. before assembly to breaker. File
away burrs after drilling. Assemble padlocking device to
breaker as explained above, then turn breaker ON and install
padlock.
Figure 1
Figure 2
Figure 4
Figure 5
Figure 3