Specifications

Thebasefile CP143H1 / TCP/IP manual
5-10 Rev. 00/07
Data base ↔
↔↔
↔ EPROM
When you select Data base ↔ EPROM from Transfer the interactive window "Data
base<>EPROM" will be displayed.
If the program responds with an error message "Eprom-driver not installed!"
the driver could not be installed.
Check the file RUNNCS.BAT for the correct path statement.
You may select a base file from one of the following 4 source / destination combinations for the
transfer:
[Dbase->EP]
You are presented with a file selection window. Select the file for the transfer. Now you
must select the type of EPROM from the module selection window. When you depress the
Enter key the data is programmed into the EPROM.
[EP->Dbase]
You will be presented with a file selection window. Enter the file name to which the data
read from the EPROM should be saved.
[NCS->EP]
You will be presented with an EPROM selection window. Select the type of EPROM you
wish to program. When you depress the Enter key the data located in the NCS is
programmed into the EPROM.
[EP->NCS]
You will be presented with an EPROM selection window. Select the type of EPROM you
wish to program. When you depress the Enter key the data is read from the EPROM and
transferred to the NCS configuration program on your PC.