Specifications

Thebasefile CP143H1 / TCP/IP manual
5-8 Rev. 00/07
5.5.3 Transferring the base file
The NCS provides two options to transfer the base file into the CP:
• by means of an EPROM that you have created using the VIPA-EPROM programmer or the
PG.
• Via the serial interface or the network in remote mode.
The menu item Transfer contains all the functions required for a data transfer between the PC, the
EPROM programmer and the CP.
5.5.3.1 Data base ↔
↔↔
↔ MC5-EPROM
You can only use the EPROM functions if you have installed a VIPA EPROM programming
adapter into your PC (Order No.: VIPA MC5-KS85). If not, you will receive an error
message!
You may also use the PG to program EPROMs. In this case you can not use the following functions.
The adapter is compatible with the following EPROMs:
• 6ES5 376-0AA11 Memory size 16 KByte NMOS
• 6ES5 376-0AA21 Memory size 32 KByte NMOS
• 6ES5 376-0AA31 Memory size 64 KByte NMOS
• 6ES5 376-1AA11 Memory size 16 KByte CMOS
• 6ES5 376-1AA21 Memory size 32 KByte CMOS
• 6ES5 376-1AA31 Memory size 64 KByte CMOS
For the transfer you may select a base file from one of the following 4 sources:
[Dbase->EPROM]
You will be presented with a file selection window. Select the file for the transfer. Now you
must select the type of EPROM from the module selection window. When you depress the
Enter key the data is transferred to the EPROM.
[EPROM->Dbase]
You will be presented with a file selection window. Enter the file name to which the data
read from the EPROM should be saved.
[NCS->EP]
You will be presented with an EPROM selection window. Select the type of EPROM you
wish to program. When you depress the Enter key the data located in the NCS is
programmed into the EPROM.
[EP->NCS]
You will be presented with an EPROM selection window. Select the type of EPROM you
wish to program. When you depress the Enter key the data is read from the EPROM and
transferred to the NCS configuration program.