Specifications
CP143 H1 / TCP/IP manual Error messages from the NCS configuration program
Rev. 00/07 B-3
EPROM errors:
EPROM function terminated
EPROM programming was terminated by the user.
EPROM programming error
An error occurred while an eprom was being programmed. Please erase the EPROM or
exchange it for a clean one, then repeat the operation.
EPROM programmer faulty
The controller on the ISA interface board is faulty.
EPROM programmer does not exist
The interface board is faulty or does not exist.
EPROM segment error
An error occurred while a file was being loaded. Please check the file "ncs.bib".
EPROM comparison error
Differences were detected between the contents of the EPROM and the original. Please erase
the EPROM or exchange it for a clean one, then repeat the programming operation.
EPROM access error
Please erase the EPROM or exchange it for a clean one, then repeat the programming
operation.
A lack of memory occurred when the EPROM function was being executed
No more DOS memory available. Remove all unnecessary programms from main memory.
EPROM-module library not available or defective
The EPROM-module library "ncs.bib" is not accessible or has been damaged. At the DOS
prompt check that this file exists and that it is in order.
EPROM defective
Erase the EPROM or exchange it for a clean one and repeat the programming operation.
EPROM read error
Erase the EPROM or exchange it for a clean one and repeat the programming operation.
EPROM func. internal error (nullptr. detected)
This error should not occur. Please inform us if you should encounter this type of error.
EPROM area overflow
This error should not occur. Please inform us if you should encounter this type of error.
EPROM error in language area
This error should not occur. Please inform us if you should encounter this type of error.
No EPROM or incorrect EPROM inserted
The identifier of the EPROM is invalid. Check the type of EPROM and exchange if
necessary.