Specifications

Application in combination with TCP/IP CP143 H1 / TCP/IP manual
5-76 Rev. 00/07
5.11.6.6 System-tab
Fig. 5-37: Test program "System"
This window returns information about the selected host-CP.
Input fields
Remote Host IP-Address of the station to which the data must be written.
Remote Port Connection address of the external station.
Local Port Connection address of the local station. To simplify matters, you may
specify the same address for remote and local.
Buttons
Connect The connection is established and prepared for the write command.
GetState The status of the CP is returned via the connection that was established
with the Connect. The following may be displayed:
- Hardware-Stop (Run/Stop-switch on the CP is in Stop-position)
The CP can not be controlled remotely by the test program.
- Hardware-Run (Run/Stop-switch on the CP is in Run-position)
The test program is able to control the CP remotely.
- Software-Stop (Run/Stop-switch on the CP must be in Run-position)
The CP was stopped by a SetStop command.
- Software-Run (Run/Stop-switch on the CP must be in Run-position)
The CP was started by a SetRun commend.
SetStop The CP is stopped. This function is only available when the Run/Stop-
switch on the CP is in the Run-position.
SetRun The CP is started. This function is only available when the Run/Stop-
switch on the CP is in the Run-position.
Information on the
connection status and
error messages
Status display
requested with
GetState
Connection data
Host-CP contol panel:
...Status check
...in Stop
...in Run