Specifications

CP143 H1 / TCP/IP manual Software
Rev. 00/07 5-75
5.11.6.5 Send-tab
Fig. 5-36: Test program "Send"
You may use this window to send a message to a specific host processor.
Input fields
Remote Host IP-Address of the station to which the data must be written.
Remote Port Connection address of the external station.
Local Port Connection address of the local station. To simplify matters, you may
specify the same address for remote and local.
Time (10mSec) Timer interval for cyclic writes. For cyclic writes the value of the timer
must be at least 5.
Control box
UDP Here you may select an unsecured protocol for communicating.
Unsecured communications do not use virtual connections. In this
manner you may select to display only UDP-messages.
Buttons
Connect The connection is established and prepared for the write command.
Send this The data entered into the ASCII fields is written to the CP via the
connection established by the Connect.
Connection data
Information on the
connection status and
error messages
List
containing
received