Specifications
Application in combination with TCP/IP CP143 H1 / TCP/IP manual
5-74 Rev. 00/07
5.11.6.4 Receive-Register
Fig. 5-35: Test program "Receive"
In this dialogue window you can configure the reception of messages from a specific host processor.
Input fields
Remote Host IP-Address of the station to which the data must be written.
Remote Port Connection address of the external station.
Local Port Connection address of the local station. To simplify matters, you may
specify the same address for remote and local.
Control box
UDP Here you may select an unsecured protocol for communicating.
Unsecured communications do not use virtual connections. In this
manner you may select to display only UDP-messages.
AutoListen When you select "AutoListen" the program goes to receive mode. In this
mode every received message from the remote CP is displayed in the list.
Disconnects will be detected and displayed but the program remains in
receive mode. The program will continue listing messages when the
connection is re-established.
Buttons
Listen Any received messages will be listed. The listing is stopped when you
click on the "STOP" button or when the connection is terminated. You
may also stop the listing by entering new connection parameters.
ClearList All entries are deleted from the receive list and the listing will continue
from the first line of the list.
Information on the
connection status and
error messages
Connection data
List
containing
received