Specifications

Application in combination with TCP/IP CP143 H1 / TCP/IP manual
5-72 Rev. 00/07
5.11.6.2 ReadA-tab
Fig. 5-33: Test program "Read A"
This window may be used to configure an active read connection.
You must specify the data required for establishing the connection and the source from where the
data should be read.
Input fields
Remote Host IP-Address of the station from where the data must be read.
Remote Port Connection address of the external station.
Local Port Connection address of the local station. To simplify matters, you may
specify the same address for remote and local.
Time (10mSec) Timer interval for cyclic reads.
OrgKennung Type of source module
DBNo Number of the source module
AnfAdr Start address of the source module
Len Word length of the source module
Control box
UDP Here you may select an unsecured protocol for communicating.
Unsecured communications do not use virtual connections. In this
manner you may select to display only UDP-messages.
Buttons
Connect The connection is established and prepared for the read command.
Read this The requested data is read via the specified connection.
Connection data
Source data
hexadecimal repre-
sentation of received data
ASCII-representation
of received data
Information on the
connection status and
error messages