Specifications

CP143 H1 / TCP/IP manual Software
Rev. 00/07 5-31
5.8.5 List of connections
You may obtain a list of the configured connections for the respective protocol from the
configuration window. This means that the content of the connection list is dependent on the
interactive window from where the list was requested. The display will only show the connections
for a single protocol. Depress the <List>button in the interactive window to request a list of
connections. This will display a list of the connections that you have created for the respective
protocol.
Fig. 5-16: List of connections
The parameters of a connection list
No.
The number of the respective connection. Multi-connections are displayed under a single
number.
Type
This indicates the type of protocol for the connection.
SSNR
This is the frame offset. The frame offset (SSNR-offset) determines the frame from the start
address that is used as communication job by the current job. Frame offsets are normally
only used in multi-processor systems with values larger than zero. Please use the following
values when assigning frame offsets:
• Frame offset 0 for CPU 1
• Frame offset 1 for CPU 2
• Frame offset 2 for CPU 3
• Frame offset 3 for CPU 4
Range:0to3