Specifications

IP 240 Addressing
Use of the IP 240 in expansion units S5-183U, S5-184U, S5-185U and S5-186U
If you use the IP 240 in one of these EUs, set the start address on switchbank S3 as explained
above.
Setting the I/O area or the extended I/O area:
• S5-183U and S5-184U expansion units
- Set the I/O area or the extended I/O area on the interface module.
- Always put switch 2.5 on the IP in the ”off” position.
• S5-185U and S5-186U expansion units
- Set I/O area or extended I/O area on the interface module.
- Set I/O area or extended I/O area on the IP.
Note:
The module address must lie in the P area if the IP 240 is to generate process interrupts over I/O
byte PY0.
EWA 4NEB 811 6120-02 3-3