Specifications

C-3
IP 240
EWA 4NEB 811 6120-02b
Result:
The software is installed in the following directories on the target drive:
Software Directory
Counting and position decoding:
 Standard functions:
 Examples:
STEP7_V2\S7LIBS\IP240ZLI
STEP7_V2\EXAMPLES\IP240WEX
STEP7_V2\EXAMPLES\IP240ZEX
Positioning:
 Standard functions:
 Example:
STEP7_V2\S7LIBS\IP240PLI
STEP7_V2\EXAMPLES\IP240PEX
Note
If you selected a directory other than STEP 7_V2 when you installed
STEP 7, that directory will be entered.
Before you can configure your system, you must have created a project in
which you can store the parameters. You can find additional information on
module configuring in your Standard Software for S7 and M7, STEP 7 User
Manual. Only the most important steps are described below.
1. Start the SIMATIC Manager and call the configuration table in your
project.
2. Select a rack and place it at the desired position.
3. Open the rack.
4. Select the following components in the hardware catalog:
SIMATIC 400
IM-400
S5 Adapter
Please take all other information needed to configure the hardware from the
chapter “Addressing S5 Modules (Adapter Casing and IM 463-2)”.
Configuring
IP 240 Counter, Position Decoder and Positioning Module