Specifications

IP 240 Position Decoding
FB 23 LEN=75
0041 :R Q 12.5 -FAULT
0042 END
0043 :A I 4.2 -ON INTPNT
0044 := F 12.1 -EDGE SET EDGE FLAG
0045 :BE
I 4.2 = ON INTPNT TRANSFER OF THE NEW INITIAL POINT
F 12.1 = EDGE EDGE FLAG OF I ”ON INTPNT”
FY 2 = AUX BYTE1 SCRATCH FLAG CYCLIC PROGRAM
F 11.5 = PAFE ZERO FOR WRITING ZERO OFFSET (FB23)
F 11.1 = PAFE ACT1 FOR READING ACTUAL VALUE AND STATUS BITS (FB23)
F 0.0 = ZERO SIGNAL FLAG ALWAYS RETAINS SIGNAL STATE ZERO
Q 12.3 = RET INTPNT INITIAL POINT MUST BE TRANSFERRED BEFORE RESTARTING
Q 12.2 = ENABLED NEW RUN POSSIBLE
Q 12.5 = FAULT ERROR MESSAGE FROM THE CONTROLLER (IP)
EWA 4NEB 811 6120-02a 7-47