Installation guide

Setup

Siemens Building Technologies

Fire Safety & Security Products 08.2007

SISTORE MX NVS supports the following network cameras:

Arecont Vision 2100, Vision 3130 Day, Vision 3130 Night

Axis 205, 206/W, 206M, 210, 211, 212 PTZ, 213 PTZ, 216FD, 221, 223M,

231D+, 232D+, 240Q, 241Q, 241S, Generic HTTP Interface V1.0,

Generic HTTP Interface V2.0

CBC MP2A, MP3DN Day, MP3DN Night

Digilan TV7214

Eneo ENC-1003L

IQ invision IQ501, IQ603, IQ 752

JVC VN-C10U; VN-C30U, VN-C625U, VN-C655U

Lumenera LE175C, LE275C, LE375C

Mobotix D12 one or two cameras, M1 Models, M10 Models, M10D-Night,

M12 Models, M12D-Night, M22M

Panasonic KX-HCM-280, WV-NM100/G, WV-NP244E, WV-NP472, WV-NS202,

WV-NS320, WV-NW470

Pixord 205

Samsung SNC-L200

Siemens CCIS1337-LP, CCIx1345, CFVA-IP NTSC, CFVA-IP PAL,

CVVA-IP NTSC, CVVA-IP PAL, TELSCAN WEB Server

Sony Generic HTTP interface, SNC-CS11, SNC-CS3P, SNC-DF40P,

SNC-M1/W, SNC-M3/W, SNC-P1, SNC-P5, SNC-RZ25P, SNC-RZ30P,

SNC-Z20P, SNT-V704

VINWP1 2051

Vivotek MJPEG Models, PZ6122, VS2402

Depending on the functional scope of the network camera, many operating

elements of the LAN cameras tab may be disabled.

Altogether a maximum of 32 network cameras can be connected.

Limitation: Network cameras cannot be connected to analogue video outputs.

Access to network cameras takes place with significantly greater latency. The

reason for this is the greater communication load between the SISTORE MX NVS

and a network camera.

Network cameras cause a significantly higher processor load of the SISTORE MX

NVS than analogue cameras. The frame rates required are the determining factor.

The operation of the system can be slow if all connections for network cameras

(32) are used.

NOTE:

To keep the processor load below 90 %, we recommend setting the resolution of network cameras

low (CIF format). The image quality should be set to approximately 70 %. The following rule applies:

The higher the performance of the server PC, the higher the image quality and the lower the

processor load. See Section. „System requirements“, page 56.

Exact specifications for the image quality and the required hard drive capacity are

not possible with network cameras, since each network camera has different

quality levels and interprets specifications differently.