User Manual

Fig. 4-51: Final Assign IP Address dialog box
In case corrections are required to the configuration, refer to LANTRONIX
documentation via the Web or Telnet on the process.
4.3.3.4 Configure virtual COM ports on the PC
A virtual COM port should be setup on the PC so that the key client can talk to the chip
encoder via IP. Detailed information is available in the LANTRONIX documentation,
located on the installation CD in the XPort folder. The following describes a sample
configuration using the CIN Port Redirector.
The chip encoder must be connected to the network via Ethernet. The CPR Manager is
then started.
Check device settings
Set up virtual COM port
43/80
Siemens Hotel Solution - System software for Windows XP CM110600en
Building Technologies Siemens Hotel Solution system setup on a PC 2014-07-07