User Manual

Entering <R> or <r>, followed by the required address parameters, displays the RCU
state as stored internally by the DGU driver.
Fig. 6-17:"RCU State" with address inputs
Fig. 6-18: RCU State output of information for internal DGU management
If you enter <M> or <m>, followed by the required address parameters and <E> or <e>
for "Enable", all incoming datagrams for the specified room controllers will be displayed
on the DGU console interface from that point on.
To disable the output, select the Set Monitor command again and, after entering the
address parameters, enter <D> or <d> for "Disable".
RCU State command
Set Monitor command
71/82
Siemens Hotel Solution - System software Service Pack 2 for Windows 7 020_A6V10444517_en--_a_--
Building Technologies Troubleshooting 2014-07-07