User Manual

4.2.2.2 Configure IP interface for a chip encoder
The device must first be configured to use the IP interface for a chip encoder. Detailed
information is available in the LANTRONIX documentation, located on the installation
CD in the XPort folder. The following describe a sample configuration using the device
installer.
The chip encoder must first be connected via the Ethernet with the network where the
computer is connected.
Then start the Device Installer. An automatic search begins upon startup and may take
some time.
The following interface appears once the device is found:
Fig. 4-28: Start Device Installer
You can now assign a static IP address with Assign IP.
Fig. 4-29: Dialog box to enter the MAC address
Click Next to open the Assignment Method dialog box.
Configure IP interface
for a chip encoder
Enter MAC address
29/82
Siemens Hotel Solution - System software Service Pack 2 for Windows 7 020_A6V10444517_en--_a_--
Building Technologies Siemens Hotel Solution system setup on a PC 2014-07-07