User Manual

6 / 14 For internal use only
Siemens HMI CM2B6307en
Building Technologies Display and operating pages 12/15/2008
3.1 First page.
The first page of the HMI provides the address settings for the room controller.
HRC3.1 HRC3.2
Parameter Description Can this
field be
edited?
HMI version HMI template version number. No.
Act.Addr Current address for the controller. No.
New Addr Setting for the new controller address. Yes.
EIB State of the KNX bus controller on the controller.
This parameter is not available for HRC3.2.
OK = Bus connection is OK.
Err = Bus connection error. Possible causes:
– KNX bus is not connected.
– No bus power supply.
No.
FacSave Conducts a backup of the factory settings. Should be executed
after a change of address. The controller restarts when changing
over from passive (pas) to active (act.).
On the HRC3.1, becomes visible by turning off the display.
Yes.
next Queries the diagnostics page. Yes.