User Manual

8/16
Siemens FOS FIDELIO ⇔ HOTEL SOLUTION link CM110603en
Building Technologies Operating the link 09/30/2008
3 Operating the link
3.1 The main menu
To display the main menu, start the link software and press any key. You can now
operate the functions of the link, and display link status information. Only the main
menu features are shown here. This section describes how they operate.
This is shown below the title bar. The possible states are:
Database
: connected
or
: not connected
("not connected" is highlighted in red)
This is shown on the next line. The possible states are:
Link to Fidelio online
: yes
or
: no
("no" is highlighted in red)
The main menu is shown under the connection status information, and contains the
following commands:
Initiate Database Swap
By selecting this option, you can request
synchronization with the FIDELIO database. A dialog
box is displayed, in which you can answer the prompt
with <y> (Yes) or <n> (No).
Display Configuration
This command allows you to display the current link
configuration
Beep
Use this command to enable or disable the audible
warning signal transmitted if the online connection with
FIDELIO is interrupted.
When you start the Fidehot link, the default setting is
"on".
Fig. 3-1: Main menu for Fidehot link
Database connection
status
Current status of the
connection to FIDELIO
Main menu
Note