Operation Manual

Trouble shooting en
35
5. Press the front panel down until it clicks audibly into
place (fig. %).
6. Open the appliance door again slightly and remove
the tea towel.
7. Screw both screws back in on the left and right.
8. Put the cover back in place and press on it until it
clicks audibly into place (fig. &).
9. Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3Trouble shooting
Trouble shooting If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Note: If a dish does not turn out as well as you had
hoped, refer to the table section at the end of the
instruction manual, where you will find plenty of tips and
information. ~ "Tested for you in our cooking studio"
on page 39
Fault table
If an error message beginning with 'E' is shown, e.g.
E0111, switch the appliance off and then on again. If
this message appears again, contact the after-sales
service.


Fault Possible cause Information/remedial action
The appliance does not work The fuse is faulty Check in the fuse box to make sure that the fuse for
the appliance is in working order
Power cut Check whether other kitchen appliances are working
The appliance door will not open; the
5 symbol is shown in the display
The appliance door is locked until the cooking com-
partment has cooled down.
Wait until the 5 symbol goes out
Although the appliance is switched
on, it cannot be operated; the 1
symbol is shown in the display
The child lock is activated
Press and hold the 1 button until the 1 symbol
goes out
E8010
The appliance door was opened immediately after the
‚
button was pressed.
Close the appliance door and press the On/Off button
The interior lighting has failed The LED bulb is defective Call the after-sales service
Operations with steam or descaling
do not start or do not continue
Water tank empty Refill water tank
The panel is open Close the panel
Descaling locks operations with steam Carry out descaling
Faulty sensor Call the after-sales service
The appliance prompts you to rinse The power supply was interrupted or the appliance
was switched off during the descaling process
Once the appliance is switched on again, rinse it twice
The appliance prompts you to descale
without the counter appearing before-
hand
The set water hardness range is too low Carry out descaling
Check the set water hardness range and adjust it, if
necessary
Buttons flash Normal occurrence caused by condensation behind
the control panel
As soon as the condensation has evaporated, the but-
tons no longer flash
The cooking compartment does not
heat and "Demo mode on" is shown in
the display
The appliance is in demo mode Switch off the fuse in the fuse box and switch it back
on again after approx. 10 seconds. Switch on the
appliance and select "Demo mode off" in the settings.
The appliance will not start and
"Cooking compartment too hot"
appears on the display
The cooking compartment is too hot for the selected
dish or type of heating
Allow the cooking compartment to cool down and
start again