Operation Manual

en Before using for the first time
14
KBefore using for the first
time
Before using for the first time Before you can use your new appliance, you must
make some settings. You must also clean the cooking
compartment and accessories.
Before using for the first time
Before using the appliance for the first time, enquire
about the water hardness of your tap water from your
water supplier.
So that the appliance can reliably remind you to
decalcify it when required, you must correctly set your
water hardness range.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or non-
carbonated mineral water.
Notes
■ If your water is very hard, we recommend that you
use softened water.
■ If you only use softened water, you can set the water
hardness range to "softened" in this case.
■ If you use mineral water, set the water hardness
range to "4 very hard".
■ If you use mineral water, you must only use non-
carbonated mineral water.
Initial use
After connecting the appliance to the power or following
a power cut, the settings for initial use are shown in the
display.
Note: You can change these settings at any time in the
basic settings. ~ "Basic settings" on page 18
Setting the language
German is the preset language.
1. Use the rotary selector to select the required
language.
2. Touch the Æ arrow.
The next setting appears.
Setting the clock
The time starts at 12:00.
1. Use the rotary selector to set the current time.
2. Touch the Æ arrow
Setting the date
The default date is 1.1.2014.
1. Always touch the Æ arrow to move to the next
setting.
2. Use the rotary selector to set the current day, month
and year.
Setting the water hardness
The default water hardness setting is "very hard".
Change this setting if your water is softer. You can ask
your water supplier about the water hardness level.
1. Set the hardness using the rotary selector.
2. Touch the Æ arrow.
A message appears on the display confirming that
the initial use has been completed.
Cleaning the cooking compartment
To remove the new-appliance smell, heat up the
cooking compartment when it is empty and with the
oven door closed.
1. Remove the accessories from the cooking
compartment.
2. Remove leftover packaging, such as polystyrene
pellets, from the cooking compartment.
3. Before heating the appliance, wipe the smooth
surfaces in the cooking compartment with a soft, wet
cloth.
4. Press the On/Off button to switch on the appliance.
5. Fill the water tank.
6. Set the type of heating, temperature and added
steam, then start the appliance operation.
7. Keep the kitchen ventilated while the appliance is
heating up.
8. Use the On/Off touch button to switch off the
appliance after the indicated time.
9. Wait until the cooking compartment has cooled
down.
10. Clean the smooth surfaces with soapy water and a
dish cloth.
11. Empty the water tank and dry the cooking
compartment.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
Water hardness range Setting
0 0 softened
1 (up to 1.3 mmol/l) 1 soft
2 (1.3 - 2.5 mmol/l) 2 medium
3 (2.5 - 3.8 mmol/l) 3 hard
4 (above 3.8 mmol/l) 4 very hard
Settings
Type of heating
% Top/bottom heating with added steam
("low" intensity)
Temperature 240 °C
Duration 1 hour