User Manual

3/14
Building Technologies RXC34.1/ALG – Controller with LonWorks® interface CM2N3848en_02
12.01.2007
Suggested enclosure supplier: Spelsberg):
• Serial terminal enclosure RK 4/50 L, Order No. 616 950 01
(including DIN rail and cable gland)
• or with transparent cover: TK empty housing PS 3625-11-tm, Order No. 106 012 01
(please order DIN rail and cable gland separately)
Suggested contact guard:
• Cover type AC2, supplied by Waldner
Wago plug-in terminal blocks are used for the connection terminals.
The RXC34.1/ALG comes with connectors without strain relief.
Order No.
Connector Contact
spacing
(mm)
Conductor
cross-
section / mm
2
Without
cable strain relief
With
cable strain
relief
X1 5.08 0.08..2.5 231-302/026-000 /032-000
X3,X4,X5,X6 7.62 0.08..2.5 231-706/026-000 /034-000
X7,X8 3.81 0.08..1.5 734-204 /033-000
X9,X10 3.81 0.08..1.5 734-206 /033-000
X11,X12 3.81 0.08..1.5 734-214 /035-000
The L
ONWORKS® bus connection terminal is a type MSTB 2,5/2-ST-5,08 connector,
supplied by Phoenix Contact.
L
ONWORKS® 5.08 0.2..2.5 1757019
None
The RXC34.1/ALG controller communicates with other devices via the following ports:
• LONWORKS® bus
for communication with
− the PXR system controller or the NIDES.RX interface (to DESIGO)
− Other DESIGO RXC devices
− LONMARK®-compatible third-party devices (e.g. occupancy sensors)
• Service socket (RJ45) on the controller for:
− Service PC
The DIL programming switch block S1 is located adjacent to the connection terminals.
The switch settings are not relevant to the application.
Note, however, that DIL 1 must always be set to ON (factory-setting)
Disposal
The device includes electrical and electronic components and must not be disposed of
as domestic waste.
Current local legislation must be observed.
Connection terminals
Communication
DIP switches
STOP
Caution