Installation manual

Appendix
A31003-X7140-A100-3-76A9, 02-2006
5-34 HiPath SimplyPhone for Outlook 4.0, Administrator Manual
spadC05.fm
Command line switch
5.5.3 Attribute mapping
The definitions for attribute mapping have the form:
AttrMap.<SpName> = <AttributDatabase>
<SpName> represents the readable names for the internal attributes of SimplyPhone for Out-
look.
For partner identification, the LDAP server field AttrMap.Filter PI in the cfg file must con-
tain a rational entry. The default value for SCD searches is PhoneNumbers. This is a specially
defined field in SCD that can be used to perform an advanced search based on numbers. The
numbers are therefore stored in international format. If this field is left blank, there is a risk that
a search that does not produce any results will end in a timeout.
5.6 Command line switch
5.6.1 Setup file switches
File name: Setup.exe
Switch Description
/S Performs the complete client installation without any interaction. To deacti-
vate individual installation dialogs, you can enable the appropriate switches
in the file SP_Inst.ini, see "SP_Inst.ini of the client component" on Page
5-11.
For non-interactive installation and when using third-party TAPI providers (for
example, CAP), you must enter the value 000000 in the Locations.ini
file under UserNumber= so that a dialog for entering the extension number
appears the first time you start the system.
/v Permits the attachment of various path information (examples):
/v"INIFILE=\"D:\Folder 1\SP_Inst.ini\""
indicates the path and name of another ini file which should contain the Lo-
cations.ini file in the directory.
/v"INSTALLDIR=\"C:\Folder 2\""
indicates the path of an installation directory.