Installation manual

Appendix
A31003-X7140-A100-3-76A9, 02-2006
5-12 HiPath SimplyPhone for Outlook 4.0, Administrator Manual
spadC05.fm
Syntax of the ini files
[GENERAL] ShowDialogLicense
={0|1}
This switch controls whether or not the li-
cense dialog is displayed during installation.
Default: 1
[GENERAL] ShowDialogDestina-
tion ={0|1}
This switch controls whether or not the dia-
log for entering the installation directory is
displayed during installation.
Default: 1
[GENERAL] ShowDialogExchange
={0|1}
This switch controls whether or not the dia-
log for selecting the Exchange Server is dis-
played during installation.
Default: 0
[GENERAL] ShowDialogGateway
={0|1}
This switch controls whether or not the dia-
log for entering the gateway numbers is dis-
played during installation.
Default: 0
[GENERAL] ShowDialogReady
={0|1}
This switch controls whether or not a dialog
requesting confirmation for execution of the
installation is displayed at the end of the se-
quence of dialogs.
Default: 1
[GENERAL] ShowDialogFinished
={0|1}
This switch controls whether or not a mes-
sage is displayed indicating that the installa-
tion has concluded successfully. Default: 1
[DATA_SOURCES] CRConfigPath=
USE_LOCAL
Network path for the configuration files.
USE_LOCAL means: SPCr in the Simply-
Phone installation path.
<EMPTY> means: SPCr folder is in the same
path as Setup.exe.
See Section 2.2.7 on page 2-19.
[XPRESSIONS_450] ShowDialog={0|1} This switch controls whether or not the dia-
log for inputting the two digit sequences for
integrating Xpressions450 is displayed dur-
ing installation. If not, the values, which are
specified further down in the sections
[XPRESSIONS_450] or in the file Loca-
tions.ini, are applied as are. Default: 1
Section Entry Description