Installation manual

Installing SimplyPhone for Outlook

A31003-X7140-A100-3-76A9, 02-2006

2-28 HiPath SimplyPhone for Outlook 4.0, Administrator Manual

spadC02.fm

Installing the driver and software in a third-party environment

2.4.2 Installing TAPI 120 for HiPath 3000 with LIM module

The following describes how to install the TAPI 120 V2.0 Service Provider together with a Hi-

Path 3000 with LIM module. Up to five CTI clients can be operated on the LIM module.

If you need detailed information, refer to the installation and configuration manual for HiPath

TAPI 120 V2.0.

If CTI TAPI is already installed on the PC, it must first be uninstalled. Administrator rights are

required to install the HiPath TAPI 120 V2.0 driver.

1. Install the installation CD and start the setup.exe file in the relevant "TAPI 120 V2.0" di-

rectory.

2. Select TAPI 120 SP V2 as the setup type and follow the instructions for the setup routine.

3. The TSP configuration dialog opens automatically once the TAPI has been successfully in-

stalled. Select LIM as the system and enter the necessary parameters here:

– own phone number (DID only)

– name of the TAPI line (freely selected)

– IP address of the LIM module

– port number of the LIM module

4. Finish configuration with OK. Installation is now complete. You must restart the PC.

You can also modify the configuration later in the configuration dialog by selecting

<Name of the TAPI line> | Configure.