Installation manual

spadC02.fm
A31003-X7140-A100-3-76A9, 02-2006
HiPath SimplyPhone for Outlook 4.0, Administrator Manual
2-5
Installing SimplyPhone for Outlook
Requirements
First-party environment
SimplyPhone for Outlook can be operated with the telephones listed in the table. Your system
administrator must have checked and ensured the telephone requirements are met and your
telephone must be correctly configured for the relevant features. Ensure that the telephone is
connected with the appropriate cable and is working.
The TAPI Service Provider driver required depends on the communication system and tele-
phone used. The TAPI Service Provider driver should be installed as indicated in the appropri-
ate installation manual (see also Section 2.3.1, "Installing the TAPI Service Provider driver").
Communication
system
optiPoint 500/410/420
(connection over USB cable or
LAN)
*
* A special USB cable (Siemens serial number: S30267-Z360-AS30) is needed for connecting the cli-
ent PC and telephone. The telephone firmware must be MP01.03 or higher.
To check the telephone, press "<" until "Service Menu Key?" appears on the display - press "
" -
press "<" until "Phone Test?" appears - press "
" - press "<" until "Software version?" appears - press
"
" and compare the firmware version (> MP0103).
optiset E with data adapter
(connection over serial V.24 ca-
ble)
**
** The version number of the data adapter must be B614-4 or higher.
HiPath 4000 CallBridge TU (CorNet WP) CallBridge TA (CorNet WP)
HiPath 3000/5000 CallBridge Collection CallBridge Collection
Hicom 300 E/H CallBridge for Desktops CallBridge for Desktops