Operation Manual

Call Processing Application Assistant – Applicatio
n
A31003-S2330-B692-3-7619, August 2003
HiPath Xpressions V3.0 Automated Attendant, User Guide
37
Introduction
– Enter the timeout time in seconds for standard menus in the Timeout for default
menus input field.
– Enter the timeout time in seconds for Announcements - Start/End in the Timeout for
Announcements - Start/End input field. The timeout is for announcements interrupt-
ed by callers. After the timeout runtime, the announcement is output again from the
beginning.
– Enter the timeout time in seconds for connection in the Timeout during connection
input field.
– You can activate the check box Do not route via PBX? to cause calls not to be routed
via the telecommunication system but via Xpressions.
– You can specify when a message should appear on the monitor to tell you that the "Lis-
ten/Respond" mailbox or a mailbox referenced by the call transfer type Mailbox in
guest access mode is full. Use the combo box Logging level for full mailbox to do
this.
– Settings for Mailbox in guest access mode can be edited in the lower part of the di-
alog box.
– The number of times the announcement is repeated in guest access mode is defined
in the Number of tries to play greeting input field.
– The maximum length of the answer to be recorded is defined in the Max. length of
recorded answer input field. This can be between 10 and 999 seconds.
– The maximum number of answers to be recorded is defined in the Max. number of
recordings input field. This can be between 0 and 999. If the input field is left empty,
or filled with the value 0, the maximum number is not restricted.
– Push the Savebutton to save the modified data.