Operation Manual

Activating a Call Processing Application
Introduction
A31003-S2330-B692-3-7619, August 2003
20 HiPath Xpressions V3.0 Automated Attendant, User Guide
– Assign the e script cpf.e to the Telematik protocol created.
– Set the application name via the script parameter:
– AppName=
– Set the transfer type via script parameter:
–if -bt is given as a parameter, a blind transfer will be performed;
otherwise, a supervised transfer.
Remark: If several parameters are used, separate them with spaces.
● WEB APL Settings
–The CPAAWeb.vo protocol must be enabled on the CGI tab under Settings → WebA-
pl → Set Options.
● Setting the number range for the Telematik protocol created
– The number range must contain the dial-in number(s) configured in the CPAA for the
call processing application. As for all Telematik scripts, you must ensure that the num-
ber range entered corresponds to the digit sequence which is transferred by the con-
nected PABX during calls. This can differ from the sequence originally selected.
For more information, see also the example in Section 4.5, "Activating a CPA".