Hicom 300 Key300 Programming Instructions 8600 TH 17.08. 13:42 Your Line Ringer on/off Shared Line 5 - Shared Line 1 - Shared Line 6 Macro Shared Line 2 - Shared Line 7 Remind Shared Line 3 - Shared Line 8 Call Journal Shared Line 4 - Shared Line 9 Conference Call Fwd-Preset Call Fwd-Variable Message Wait Message Retrieve Call Fwd-Off Call Fwd-Cancel Menu / Esc - 2nd Level - OK - 1 2 3 Disc Last No 4 5 6 Clear Save No.
Programme Keys This abbreviated programme manual is intended for use by Customer Support, 1st Line Maintenance and System Administrator personnel. A fully comprehensive Service Handbook is also available. The basic configuration of the instruments is programmed on the Service Terminal. The Key300 differs from the normal digital instruments on the Hicom 300 insofar as most of the programming of the keys is carried out on the instrument.
Notes Most keys are progammed by simply entering the key code. Other keys require more information. Fixed keys - Menu / Esc, OK, Volume and Dial pad. All other keys, with the exception of the Loudspeaker key, can be programmed on the 1st and 2nd levels. The KLMU module will accommodate 16 Set 551’s and a combination of 30 lines or DSS keys in one or more groups. Selected lines can be multipled over 2 or more instruments. To programme a key which is not vacant it must first be deleted.
Programme key - Special Dial (Destination) - press Menu / Esc key press 2nd Level key if required press vacant key enter code 01 press OK key press OK key again or enter required number and OK key DSS - press Menu / Esc key - press 2nd Level key if required - press vacant key - enter code 02 - press OK key - press new DSS key to scroll for required device number - press OK key - press 0 or 1 for CALL MEMORY ACTIVE? (Call Journal) - press OK key This key will not be operational until the associated key has
Ring Transfer Own or Remote - press Menu / Esc key - press 2nd Level key if required - press vacant key - enter code 05 (Own) or 06 (Remote) - press new Ring Transfer key to scroll for new numbers if required - press OK key - press DSS key for required device - press OK key Line - press Menu / Esc key - press 2nd Level key if required - press vacant key - enter code 03 - press OK key - enter PASSWORD - press OK key - enter required LINE NO.
Wizard Menu Programme Device Name - press Menu / Esc key press ∗ key press 0 enter name of device owner e.g.
