Basic Documentation

9 / 42
Siemens VAV Compact Controller Modbus RTU A6V10631862_en--_e
Smart Infrastructure 2021-10-26
2.2 Design and device parts
The VAV Compact Controllers consist of a differential pressure sensor, actuator
and digitally configurable control electronics. They are intended for mounting on
damper shafts of a minimum length of 30 mm. They consist of base and 2-sectional
housing.
Components contained in the base:
• Steel base plate with damper drive shaft fixing for different drive shaft
diameters / cross-sectional areas (cf. section 2.3) and angular rotation limiter,
• maintenance-free, low-noise gear train,
• magnetic hysteresis clutch with practically contact-free force transmission; this
means that the actuator is locking- and overload-proof, also in continuous
operation.
Components contained in the housing (Note: the housing cover can’t be
removed):
• controller electronics,
• differential pressure sensor,
• synchronous motor for the damper actuator.
1 Shaft attachment screw
2 LED
3 Push button
4 Configuration and maintenance interface (below cover)
5 Connection nozzle for measuring differential pressure in
the VAV box
6 Connection nozzle for measuring differential pressure in
the VAV box ("+": Side with higher pressure)
7 Two connecting cables (power and communications),
2-core each
8 Disengagement of gear train
9 Rotation angle display
10 Rotation angle check screw
Manual control of the air dampers is possible by gear train disengagement (8)
when the VAV Compact Controller is disconnected from the power supply.
2.3 Dimensions
min. 100
min. 200
min. 80
min. 6
8 20
ø7
2
5
180
X
8 - 16 mm
12.8 mm
15 mm
3547M01
14 x 12
X =
4.15
71
26.5
87
158
137
Ø 3...8
43
41.3
61
9.6
Measures in mm
2
3
4
5
8
9
10
3547J01
6
1
7
Main device parts
Gear train
disengagement