Specifications

6
The Gigaset SE587 WLAN dsl
Gigaset SE587 WLAN dsl / eng / A31008-N1083-L171-1-7619 / introduction.fm / 12.12.2007
Schablone 2004_08_26
LED displays
The upper side of the device has LED displays that show the operating state and simplify
installation and troubleshooting in the network.
The LEDs show the following:
*) If the Internet session is dropped due to an idle timeout, the light will remain green
as long as a DSL connection is still present.
LED State Status
Power
On (green)
The device is powered on and has been booted success-
fully.
Flashing
(green)
System is booting.
Off The device is powered off.
On (red)
The device cannot be booted or a malfunction has been
detected.
LAN1 –
LAN4
On
A device is connected to the relevant LAN port and a
connection has been established.
Flashing The LAN port is transmitting or receiving data (traffic).
Off
There is no device connected or the connected device is
powered off.
WLAN
On
The wireless interface is activated, no data transmission
at present.
Flashing
The device is transmitting or receiving data on the wire-
less interface.
Off The wireless interface is deactivated.
ADSL
On
The device is connected to the ADSL port of the splitter
and the ADSL connection has been synchronised suc-
cessfully.
Flashing The ADSL connection is being synchronised.
Off
There is no connection to the ADSL port of the splitter or
the ADSL connection cannot be synchronised.
Online
On (green) A connection to the Internet has been established. *)
Flashing
(green)
The device is transmitting or receiving data from or to
the Internet.
Off There is no Internet connection.
On (red)
Device attempted to establish an Internet connection
and failed.