Operation Manual

19
Setting up the base station – Getting started wizard
7G_8G_HS_an_ ISDN-Basen / en / A31008-M1751-X101-2-7619 / starting.fm / 29.10.2007
Operation on a PABX
Only carry out the following steps if you want to connect your telephone to a private
PABX (not directly to the NTBA). Depending on the PABX, it may be necessary for you to
enter an access code (outside line code) for external calls during installation; refer to the
operating instructions for your PABX for details. You can enter an access code (one to
four digits).
The display shows: Operate behind PABX?
The display shows Installation completed. Press the End call key a, to return the hand-
set to idle status.
[RRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
Press the display key to confirm the prompt.
[RRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
Press the display key to confirm the Set access
code? prompt.
~
Entering the access code (outside line code)
Í
Press the display key to open the submenu.
s
Save entry
Select and confirm. The Getting started wizard is
closed.
OK