Operation Manual

15
Setting up the base station – Getting started wizard
7G_8G_HS_an_ ISDN-Basen / en / A31008-M1751-X101-2-7619 / starting.fm / 29.10.2007
Example of how to assign an MSN:
You have requested four MSNs, two for business use (MSN1, MSN2) and two for private
purposes (MSN3, MSN4). Four handsets are connected to a base station. Two handsets
(Int.11 and 12) and the answering machine AM 91 are intended for business use, and
two handsets (Int.13 and 14) and the answering machine AM 92 are intended for pri-
vate use.
Because internal 11 and internal 12 handsets are each assigned two (receive) MSNs,
they can use the MSN next call feature (page 72). They can switch to (send) MSN2 dur-
ing each outgoing external call. In this example, the internal 13 and 14 handsets cannot
do this.
Launching the Getting started wizard and making the basic settings
Internal subscribers Use Receive MSN Send MSN
Handsets Int.11, 12 Business MSN1, MSN2 MSN1
Answering
machine
AM 91 MSN1, MSN2 ---
Handset Int.13 Private MSN3 MSN3
Handset Int.14 MSN4 MSN4
Answering
machine
AM 92 MSN3, MSN4 ---
v / w ¢ Ð ¢ Base ¢ Installation
[RRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
Press the display key to launch the Getting started
wizard.
If you already have set a system PIN (not 0000)
(page 65), you will be asked to enter it.
~
If required, enter the system PIN and confirm.
OK
i
◆ The Getting started wizard cannot be used simultaneously by multiple
handsets.
◆ If the settings already contain data (factory defaults or previous
settings), this data is shown at the appropriate positions in the display
and can be modified there.
◆ To cancel the Getting started wizard, press and hold the End call key.
All changes you have already saved using Save entry
§OK§ are retained.
The handset returns to idle status.
◆ To skip a setting, press the §NO§ display key.