User guide

70
Service (Customer Care)
Gigaset C590/C595 / GBR / A31008-M2101-L101-1-7619 / appendix.fm / 29.04.2009
Version 4, 16.09.2005
Gigaset C595 only:
Authorisation
This device is intended for analogue
phone lines in the UK.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the
essential requirements and other relevant
regulations laid down in Directive 1999/5/
EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs
.
You cannot hear a ringtone/dialling tone
from the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong pin connections.
¥ Please always use the phone cord supplied
or ensure that the pin connections are cor-
rect when purchasing from a retailer
(
¢ page 10).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥ Reset the system PIN to 0000 (¢ page 66).
Forgotten the system PIN.
¥ Reset the system PIN to 0000 (¢ page 66).
The other party cannot hear you.
You have pressed the mute key h.
The handset is "muted".
¥ Activate the microphone again
(
¢ page 29).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥ The caller should ask the network provider
to enable Calling Line Identification (CLI).
You hear an error tone when keying an input
(a descending tone sequence).
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user
guide if necessary.
You cannot listen to messages on the net-
work mailbox.
Your PABX is set for dial pulsing.
¥ Set your PABX to tone dialling.
No time is specified for a message in the call
list.
Date and time have not been set.
¥ Set the date/time (¢ page 15).
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥ Enter the system PIN again.
2. The system PIN is still set to 0000.
¥ Change the system PIN (¢ page 66).
The answering machine is not recording any
messages/has switched to announce only.
Its memory is full.
¥ Delete old messages.
¥ Play back new messages and delete.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain acti-
vated or deactivated. As a pixel is made
up of three sub-pixels (red, green,
blue), it is possible that pixel colours
may vary.
This is completely normal and does not
indicate an error.