Operation Manual

15
A400/A400A / GBR / A31008-M2201-L101-3-7619 / main.fm / 19.06.2013
Specifications
Recommended batteries
Only use rechargeable batteries as described below.
Technology: Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 400–800 mAh
The device is supplied with two approved batteries.
Base power consumption
General specifications
Questions and answers
If you have any queries about the use of your tele-
phone, visit our website at 
www.gigaset.com/service 
for assistance 24/7. The table below contains a list of
common p
roblems and possible solutions.
In standby mode
- Charged handset in base
- Handset not in base
approx. 0.7 W
< 0.4 W
During a call approx. 0.5 W
DECT standard Is supported
GAP standard Is supported
(The Gigaset handset is only fully
func
tional on Gigaset bases)
Range Up to 300 m outdoors 
Up to 50 m indoors
Base power supply 230 V ~/50 Hz
Environmental condi-
tions in operation
+5°C to +45°C, 20% to 75% relative
hu
midity
Standby time 220 hours
Talktime 20 hours
Operating time for 1.5
hours
of calls per day
- Without Eco Mode+ 
- With Eco Mode+
135 hours
90 hours
Charging time in
cha
rger 5.5 hours
Problem Cause Solution
Nothing
appears in the
display.
The handset is not
switched on.

The batteries are
fla
t.
Press the end call key
a for approx.
5 seconds or pl
ace the
handset in the base.
Charge or replace the
batter
ies.
No wireless
connec
tion to
the base, Base
flashes in the
display.
The handset is out-
side the range of
th
e base.
The handset is not
re
gistered.
The base is not
switched on.
Move the handset
clos
er to the base.
Register the handset
¢ page 12.
Check the mains con-
nector on the base
¢ page 4.
You cannot
hear a r
inger
melody/dial-
ling tone from
th
e fixed line
network.
The phone cord
sup
plied has not
been used or has
been replaced by a
new cord with the
wrong pin connec-
tions.
Please always use the
phon
e cord supplied or
ensure that the pin
connections are cor-
rect when purchasing
fr
om a retailer: 3-4
assignment of tele-
phone leads/EURO
C
TR37.
Error tone
sou
nds after 
system PIN
p
rompt.
PIN forgotten.
You have entered
the
wrong system
PIN.
Reset the system PIN to
the default setting
0000 ¢ page 13.
All handsets are de-
r
egistered. All settings
are reset. All lists are
deleted.
The connec-
tion always
ter
minates
after approx.
30 seconds.
Repeater acti-
vated/deactivated
¢ page 14.
Deactivate and
reac
tivate the handset
¢ page 7.