Specifications

159
Appendix
Giga762SX WLAN dsl / eng / A31008-M705-W171-1x-5819 / appendix.fm / 02.07.2008
Schablone 2005_07_27
After a WPS registration
attempt, the WLAN LED
continues to flash for some
time and the required client
was not registered.
u More than one client has tried to register.
ì Repeat registration after a short interval.
u MAC access control is activated, but the desired cli-
ent is not in the MAC address list.
ì Add the client to the MAC address list (see
page 58).
If the MAC address filter is enabled a WPS registration
attempt can not be detected by the device. In this case
LED signalling is not possible.
After a WPS registration the
WLAN LED shows successful
registration but the desired
client was not registered.
Maybe an external device has registered with your net-
work.
ì Change the WPA PSK key manually as soon as
possible (see page 89) and perform the WPS
registration via PIN (see page 87).
You cannot open a connec-
tion to the Giga762SX
WLAN dsl from a wireless
device.
u You attempted to perform WPS registration on the
network adapter but the registration button was
not activated on the Giga762SX WLAN dsl.
ì Press the Registration button (Scan button) on the
Giga762SX WLAN dsl and activate WPS within the
two-minutes interval on the network adapter.
u You defined a PIN for WPS registration but the net-
work adapter does not use a PIN or uses a different
one.
ì Check the wireless network encryption settings and
determine the PIN used by the Giga762SX WLAN
dsl. Enter this PIN on the network adapter.
u You defined a PIN for WPS registration at the net-
work adapter but you didn’t enter this PIN at the
Giga762SX WLAN dsl PIN or not the right one.
ì Find out the PIN that is used by the network
adapter. Enter this PIN on the Giga762SX WLAN dsl.
u The wireless network adapter is not using the cor-
rect SSID.
ì Change the SSID on the network adapter or use the
WPS function.
Symptom Possible cause and solutions