Network Router User Manual

GINA V4.0 System Administrator Guide – September 2000 21
Installation
Druck vom 24. 01.2001 17:00.22 install
3.3.5 Environment variables
Certain environment variables must be set when implementing the various components of
GINA. Depending on the components implemented, these variables are:
Using the T-ORB on basis of open UTM
UTMPATH This environment variable contains the path of the installed open UTM envi-
ronment.
UPICPATH This environment variable contains the name of the directory with the
upicfile file. upicfile is created using the configuration generator
config (see chapter 6 on page 43).
This variable need only be set if you are starting a client application in a di-
rectory other than that containing the upicfile file.
GINACONFIG This variable is used to select a directory other than the actual directory for
the servernames file generated by config for the execution of a client
application.
Using the T-ORB on basis of BEA TUXEDO
TUXDIR This environment variable contains the path to the BEA TUXEDO installation
directory.
TUXCONFIG This environment variable contains the name of the TUXCONFIG configura-
tion file.The absolute path name must be specified here.
This file is created using the crbincf script generated by the config-tux
configuration generator.
BDMCONFIG This environment variable contains the name of the BDMCONFIG configura-
tion file. The absolute path name must be specified here.
This file is created using the crbincf script.
This variable need only be set if you are using the Domains component
from BEA TUXEDO.
GINACONFIG This variable is used to select a directory other than the actual directory for
the servernames file generated by config-tux for the execution of a cli-
ent application.