Network Router User Manual

GINA V4.0 System Administrator Guide – September 2000 15
Installation
Druck vom 24. 01.2001 17:00.21 install
3.3 Installation
The installation procedures depend on the system base. The variants described here are
examples only.
You must always perform installation and deinstallation in accordance with the description
of your system base or the information in the Release Notice. ❍❍●
GINA is shipped as a package which is created using a system-specific packet assembly
procedure (package under UNIX, setup under NT). The full-feature version of GINA V4.0
under UNIX is divided up into subpackages so that you do not have to install the entire prod-
uct folder. The functional scope of a full-feature version can only be achieved by installing
all of the subpackages.
The names and contents of the subpackages as well as the order in which they must be
installed can be found in the Release Notice.
Depending on the selected variant, GINA builds on standard products ( open UTM, INFOR-
MIX). These must be installed using their own installation procedures and are not described
here.
If the GINA package is stored on the delivery CD as a file in compressed format, it must be
copied to an intermediate directory and unpacked prior to installation (refer to the descrip-
tion for the relevant platform).
The following actions, for example, must be carried out to install GINA itself on the platforms
listed below.