Network Router User Manual

138 GINA V4.0 System Administrator Guide – September 2000
Creating a configuration file using WinConfig
The following table describes the dialog window entries; the “Statement” column specifies
the corresponding statement that is generated by WinConfig when saving to a configura-
tion file.
The buttons in the dialog window execute the following actions:
OK The entered additional parameter values are confirmed.
Delete All additional parameter values are deleted.
Cancel The modified parameters are discarded again.
Parameter name Value Default Statement
Access Mode of access to the additional data area.
Possible values:
DIRECT
INDIRECT
Selected via a pull-down menu.
(This parameter only exists for OS_UNIX
or OS_WINNT.)
- AREA
Load Specifies when and where the data range
is to be loaded. Possible values:
STATIC
POOL
Selected via a pull-down menu.
You must specify a poolname with POOL.
(This parameter only exists for
OS_BS2000.)
- AREA
Poolname Name with which the data area in the com-
mon memory pool is loaded.
(This parameter only exists for
OS_BS2000.)
None AREA
Load-Module Name of the load module in which the
module (i.e. the data area which can be
used jointly) is linked.
(This parameter only exists for
OS_BS2000.)
None AREA
Lib Program library from which the module is
to be dynamically loaded or linked.
(This parameter only exists for
OS_BS2000.)
None AREA