Network Router User Manual

GINA V4.0 System Administrator Guide – September 2000 131
Creating a configuration file using WinConfi
g
Druck vom 24. 01.2001 17:00.49 torb-kon
Netaccess...
Customizes the NETACCESS statement.
The following dialog window is opened when this menu item is called:
Figure 21 Dialog window: Netaccess system
The following table describes the dialog window entries; the “Statement” column specifies
the corresponding statement that is generated by WinConfig when saving to a configura-
tion file.
The buttons in the dialog window execute the following actions:
OK The entered parameter values are confirmed.
Delete All parameter values are deleted.
Cancel The modified parameter values are discarded again.
Parameter name Value Default Statement
Netaccess Linking of the application to the network.
Possible values:
S-Thread (SINGLE-THREADED),
M-Thread (MULTI-THREADED),
M-Thread-All (MULTI-THREADED,ALL)
- NETACCESS