Network Router User Manual

GINA V4.0 System Administrator Guide – September 2000 117
Creating a configuration file using WinConfi
g
Druck vom 24. 01.2001 17:00.43 torb-kon
d) Editing sessions
A session between two TA applications is represented graphically by a connecting line
between the two icons. A session between two TA applications is generated by clicking
once on the two relevant icons with the left mouse button.
The session parameters can be edited by clicking on the connecting line with the left mouse
button. A dialog window that is positioned on the first icon that was clicked on is displayed.
This TA application is then the “Me application”. The other TA application represents the
“Other application”.
Figure 11 Dialog window: Session parameters
The following table describes the dialog window entries; the “Statement” column specifies
the corresponding statement that is generated by WinConfig when saving to a configura-
tion file
The buttons in the dialog window execute the following actions:
OK The entered parameter values are confirmed.
Delete The corresponding session is deleted, i.e. the line between the two icons in
the application edit window disappears.
Cancel The entered parameter values are discarded again.
Parameter name Value Default Statement
Protocol Name of the protocol used LU6.1 SESSION
Me -> Other Number of connections controlled
by the Me application
1 SESSION-POINT
Other -> Me Number of connections controlled
by the Other application
1 SESSION-POINT
Map_System Enable/disable mapping,
see section SESSION on page 62.
Possible values: yes / no
Selected via a toggle button
no SESSION