Network Router User Manual

GINA V4.0 System Administrator Guide – September 2000 111
Creating a configuration file using WinConfi
g
Druck vom 24. 01.2001 17:00.41 torb-kon
Hosts with the BS2000 operating system do not require any port addresses or KEYVECTOR
statements. For this reason, the entries First Port, Last Port, First Key and Last
Key in the dialog window cannot be edited for BS2000 hosts.
The buttons in the dialog window execute the following actions:
OK The entered parameter values are confirmed.
Delete The corresponding host is deleted, i.e. the host icon in the host edit window
disappears.
Cancel The entered parameter values are discarded again.
An application (represented by an icon in the application edit window) that is running on a
host and whose dialog window is open is displayed by WinConfig with a frame around it.
In addition, changing the host name in the host dialog window automatically also changes
the host name of all of the applications on this host.
First Port First port number for the TNSX
entries
10000 PORTADDRESSES
Last Port Last port number for the TNSX
entries
This parameter value is calculated
automatically by WinConfig. The
calculation is explained in
section 6.2 on page 46. WinConfig
only uses the new value if it is larger
than the old value.
10000 PORTADDRESSES
First Key Start key for the KEYVECTOR state-
ment (shared memory and sema-
phore key)
1000 KEYVECTOR
Last Key End key for the KEYVECTOR state-
ment
This parameter value is calculated
automatically by WinConfig. The
calculation is explained in
section 6.2 on page 46. WinConfig
only uses the new value if it is larger
than the old value.
1000 KEYVECTOR
#T, #N, #F Number of TA, non-TA and foreign
applications running on the host
This parameter value is generated
automatically by WinConfig.
0,0,0 none
Parameter name Value Default Statement