Network Router User Manual

104 GINA V4.0 System Administrator Guide – September 2000
Creating a configuration file using WinConfig
The configuration file created using WinConfig is the input for the GINA configuration gen-
erator config. The configuration generator creates the files required for configuring the
entire system based on the information provided in the configuration file (see section 6.5 on
page 94).
This chapter explains the steps for working with the WinConfig graphical user interface.
The description requires knowledge of the configuration language specified in section 6.2
on page 46.
6.7.1 Calling WinConfig
The WinConfig graphical user interface is called as follows:
WinConfig [-V] | [ configfile ]
The interface can be started with or without a configuration file. If a configuration file is spec-
ified in the call, WinConfig tries to load this file immediately after it is started.
If the -V option is specified, only the version message is output to stdout and execution
of the program is terminated.
No environment variables or X resources must be set. However, the font, if required, can be
specified via the X resource WinConfig*fontList.