User Manual

9-9
Modular installation system, Room Control Box
Room Control Box
Modules
Siemens Switzerland Ltd
Building Technologies Division
2019www.siemens.com/gamma
9
Stock No. Product No. DT
5WG1510-2AB23 RS 510/23 A
RS 510/23Binary Output, 2 x AC 230 V, 10 A (resistive load)
• 2 oating relay contacts
• Rated contact frequency: 50/60 Hz
• Contact rated current according to DIN EN 60669-1: 10 A (resistive load)
• Bus-powered electronics
• Integrated bus coupling unit, bus connection via bus terminal
• Type of protection: IP 20
• Rated contact voltage AC 230 V
• Screw-less terminals for connection and through-wiring of untreated single-core, stranded or multi-
core conductors, 0.5 ... 2.5 mm
2
• With bus connection module
• Modular installation device for mounting in AP 118 automation module box or AP 641 room control
box
• For each output:
- Selectable operating mode (normal mode/time switch mode)
- Selectable relay mode (NO contact/NC contact)
- Status object as optional addition
- Variable On and Off delay times
- Selectable logic operation (AND/OR) of two communication objects
- Selectable switching state at bus voltage failure and recovery
- Optional addition of night mode object for time-limited switching On of the output (and hence the
illumination) at night
• Variable On period at night or time switch mode
• Selectable post-triggering of the On period (On period extension) in time switch mode
• Selectable warning signal prior to imminent switching-off by means of three-times short off and on
switching (ashing) at night or in time switch mode
• Selectable function:
- Including additional communication object for manual override of an output
- Forced control, including additional communication object for switching an output on or off in forced
mode
- Counting of operating hours and with threshold monitoring of the operating hours
- Counting of load cycles and with threshold monitoring of the load cycles
• Integrated 8-bit scene control and linking of each output into up to 8 scenes
The AP 641 room control box and AP 118 automation module box must be ordered separately.
See chapter Modular Installation System - Room control box - Module boxes.
Base function Only Switching
Rated voltage AC 230 V
Rated current 10 A
Number of channels 2
Switch-off warning Yes
Dimensions (W x H x D) 50,2 x 48,8 x 35,5 mm
7-Module boxes.indd 9 26.07.2018 14:32:19